Enerdrive Inverter Troubleshooting Guide (Non Transfer Inverters)

‼️Please Note: The below Troubleshooting guide is related to EN1110S, EN1120S. For Troubleshooting on other inverters please visit our support portal HERE

⚠️Problem: E01. The Inverter has sensed input under voltage and has shut down. 

✅Suggested Remedy: Recharge Battery immediately and restart inverter

⚠️Problem: E02. The Inverter has senses input overvoltage and has shut down

✅Suggested Remedy: Check Battery voltage and if any external charger is connected to the battery bank

⚠️Problem: E03. The inverter output has sensed overload or short circuit and has shut down. 

✅Suggested Remedy: Check Load connected to the output. Reduce the load and restart the inverter.

⚠️Problem: E04. The Inverter has senses internal temperature was high and shut down

✅Suggested Remedy: Turn off inverter, wait for 15 minutes before restarting, check if any object has blocked the airflow of the unit. Restart the inverter. 

⚠️Problem: E05. The Inverter has sensed input voltage is low and warning occurs. 

✅Suggested Remedy: Recharge Battery as unit will shutdown shortly. 

⚠️Problem: E06. Inverter has sensed load connected is close to overload shutdown limit. 

✅Suggested Remedy: Reduce Load

⚠️Problem: E07. Inverter has sensed internal temperature is high and is close to thermal shutdown limit

✅Suggested Remedy: Reduce Load and check if any ventilation of the unit is blocked. 

⚠️Problem: No output voltage and status LED is off. 

🛠️Symptom. The Unit is off. 

✅Suggested Remedy: Turn unit ON by following the instructions in section 4 of this manual 1000w-2000w User Manual

🛠️Symptom: No Power to Inverter. 

✅Suggested Remedy: Check Fuse or the disconnect switch (if installed) is either blown or turn OFF

⚠️Problem: No Output. Status LED is in Amber. 

🛠️Symptom: Check Error code on Display. 

✅Suggested Remedy. Verify the error condition and make correction. 

If you are still experiencing issues after trying the above suggested remedies please email the Enerdrive Support team 📩 support.enerdrive@dometic.com and please include your Name, Surname, Contact # and email address and a detailed description of your fault including photos of the item installed and any error codes and screen displays in your email.